  |
|||
|
|
Modelling Guides Please follow the guide below to construct the No-Go-Zone miniatures. You will need superglue and a craft knife or scapel. Painting guide to come soon... |
|
|
|
Each No-Go-Zone miniatue comes with it's own metal and plastic base. Once you have cleaned up the miniature and base of any possible flash (excess metal on the mould lines), place a few drops of super glue onto the bottom of the metal base. |
 |
|
|
|
Fit the metal base onto the plastic base putting the tab into the slot. |
 |
||
|
Once the super glue has set, make a hole with either a pin vice drill, or by twisting the point of a scalpel or craft knife into the plastic base. As an alternative, clip the end of the tab off to the correct length to fit in the hole of the metal base. However, the longer the tab, the stronger the bond.
|
   |
||
|
Add a drop of super glue to the tab and under the other foot and push the minature into the hole on the base.
|
 |
||
|
Now your miniature is constructed, let the super glue dry and it is ready to paint.
|
 |
||
Home • Contact us • Shop • Terms & Conditions • Web site designed by Warm Acre Design